144PDreadme.TXT

Unzipping the 14400pd_22.zip file will yield the following contents:

DISK1.ZIP
DISK2.ZIP
DISK3.ZIP
DISK4.ZIP
DISK5.ZIP

First unzip the file which will eventually make up a five-disk set that is 
installed via the floppy drive. So have five blank formatted floppy disks available 
for copying the install files to.

1) Insert a blank floppy disk into the floppy drive. UNZIP the file DISK1.ZIP 
onto the floppy disk. This will decompress and copy the entire contents of 
DISK1.ZIP to the floppy drive. Remove the floppy disk and label it BA14400PD 
Disk 1 of 5.

2) In a similar manner, UNZIP the file DISK2.ZIP (yields DATA2.CAB).  Label 
this floppy BA14400PD Disk 2 of 5.

3) In a similar manner, UNZIP the file DISK3.ZIP (yields DATA3.CAB).  Label 
this floppy BA14400PD Disk 3 of 5.

4) In a similar manner, UNZIP the file DISK4.ZIP (yields DATA4.CAB).  Label 
this floppy BA14400PD Disk 4 of 5.

5) In a similar manner, UNZIP the file DISK4.ZIP (yields DATA4.CAB).  Label 
this floppy BA14400PD Disk 5 of 5.

Now, let's use the installation floppies to update the BA14400PD Software. Make 
sure that the BA14400PD Analyzer is powered-on. If it is powered-on and the 
BA14400PD Application is running, then first exit the BA14400PD Application.

1) Insert BA14400PD Disk1 into the BA14400PD Analyzer's floppy drive.
2) Open the Start menu by pressing the Start button found in the lower left-
   hand corner of the display.
3) Select "Run ..."
4) In the Run dialog, type A:\SETUP and then press the OK button.  Follow the 
   Setup Wizard instructions which include inserting Disks 2, 3, 4, and 5. 
5) At the end of the installation, the Reboot? dialog will appear. After you 
   press the OK button to reboot, wait until WindowsNT writes data to the disk. 
   After the data is written to disk and while the analyzer is rebooting, remove 
   Disk 5 from the floppy drive.


Software Download Terms and Conditions
--------------------------------------
SyntheSys Research, Inc. provides utility software to assist qualified users 
in supporting applications of our instruments. While the software has been 
tested in specific configurations, we cannot guarantee that it will operate 
correctly in all applications. The software is provided for free on an “as-is” 
basis, without any representation of warranty. SyntheSys Research disclaims 
all warranties, expressed or implied, including fitness for the application 
requirements and non-infringement of intellectual property rights. In no 
event shall SyntheSys Research be liable for any direct, indirect, incidental 
or consequential damages arising out of, or connected to the use of this 
software.