6README.TXT

Unzipping this file will yield the following contents:

622DISK1.ZIP
622DISK2.ZIP

GENERAL:
These two zipped files contain the complete latest operating system and 
utilities for a BA622.  They could be used to restore (without software 
options) a completely reformatted HDD.  Each of them should be unzipped onto 
one 3.5" floppy disk and used as an installation disk according to 
the instructions below.  If complete reformatting of the HDD was 
necessary, the touch-screen must be re-calibrated using the procedure 
in the User Guide.  Call SyntheSys Research for information about how 
to restore options in case the HDD was reformatted. 

After you have unzipped it, copy all the contents of 622DISK1.ZIP onto a floppy 
disk and label it "BitAlyzer 622 Operating System Installation Disk". Also mark 
the version number on the disk. After you have unzipped it, copy all the 
contents of 622DISK2.ZIP onto a floppy disk and label it "BitAlyzer 622 
Utilities Installation Disk".  Also mark the version number on the disk.

The INSTALL program located on the BitAlyzer 622 installation disks is a 
self-extracting program used to transfer the BA622 Operating System software 
to the BA622 hard disk and to set up the software's configuration.

INSTALLATION PROCEDURE:
	1.  Power on the BA622 and get to the DOS prompt.  If the BA622 program 
	    has started, exit by using "Quit"
	2.  Insert the BitAlyzer 622 Operating System 
            Installation Disk into the BA622 floppy drive. 
	3.  Start the Installation program from the DOS mode.
            Type <a:install> <Enter>
	4.  Wait for the INSTALL program to complete.
	5.  Insert the BitAlyzer 622 Utilities 
            Installation Disk into the BA622 floppy drive. 
	6.  Start the Installation program from the DOS mode.
            Type <a:install> <Enter>
	7.  Wait for the INSTALL program to complete.
	8.  Reboot the BA622.


Software Download Terms and Conditions
--------------------------------------
SyntheSys Research, Inc. provides utility software to assist qualified users 
in supporting applications of our instruments. While the software has been 
tested in specific configurations, we cannot guarantee that it will operate 
correctly in all applications. The software is provided for free on an “as-is” 
basis, without any representation of warranty. SyntheSys Research disclaims 
all warranties, expressed or implied, including fitness for the application 
requirements and non-infringement of intellectual property rights. In no 
event shall SyntheSys Research be liable for any direct, indirect, incidental 
or consequential damages arising out of, or connected to the use of this 
software.