PREADME.TXT Unzipping the 625_4x3.zip file will yield the following contents: PDISK1.ZIP PDISK2.ZIP PDISK3.ZIP GENERAL: These three zipped files contain the complete 625--4x3 picture files for a DVA184. Each of them should be unzipped onto one 3.5" floppy disk and used as an installation disk set according to the instructions below. First unzip the files which will eventually make up a three-disk set that is installed via the floppy drive. So have two blank, formatted floppy disks available for copying the install files onto. 1) In any DOS-compatible PC, insert a blank floppy disk into the floppy drive. UNZIP the file PDISK1.ZIP onto the floppy disk. This will decompress and copy the entire contents of PDISK1.ZIP to the floppy drive. Remove the floppy disk and label it "625--4x3 Picture Files Disk 1". 2) In a similar manner, UNZIP the file PDISK2.ZIP. Label this floppy "625--4x3 Picture Files Disk 2." 3) In a similar manner, UNZIP the file PDISK3.ZIP. Label this floppy "625--4x3 Picture Files Disk 3." The INSTALL program located on the Picture File installation disk 1 is a self-extracting program used to transfer the Picture File software from the three disks to the DVA184 hard disk in the correct directory. Now, use the installation floppies to install the picture files. Make sure that the DVA184 Analyzer is powered-on. If it is powered-on and the DVA184 Application is running, pull down File-->Quit to exit the DVA184 Application. 1) Insert 625--4x3 Picture Files Disk 1 into the DVA184 Analyzer's floppy drive. 2) Type 3) Follow the instructions to install Disk 2 and Disk 3. 4) At the end of the installation, reboot the DVA184. Software Download Terms and Conditions: --------------------------------------- SyntheSys Research, Inc. provides utility software to assist qualified users in supporting applications of our instruments. While the software has been tested in specific configurations, we cannot guarantee that it will operate correctly in all applications. The software is provided for free on an “as-is” basis, without any representation of warranty. SyntheSys Research disclaims all warranties, expressed or implied, including fitness for the application requirements and non-infringement of intellectual property rights. In no event shall SyntheSys Research be liable for any direct, indirect, incidental or consequential damages arising out of, or connected to the use of this software.