HDREADME.TXT

Unzipping this file will yield the following contents: 

DISK1.ZIP 
DISK2.ZIP 
DISK3.ZIP 
DISK4.ZIP 
DISK5.ZIP 

First unzip the file which will eventually make up a five-disk set that is 
installed via the floppy drive. So have five blank formatted floppy disks available
for copying the install files to. 

1) Insert a blank floppy disk into the floppy drive. UNZIP the file DISK1.ZIP 
   onto the floppy disk. This will decompress and copy the entire contents of 
   DISK1.ZIP to the floppy drive. Remove the floppy disk and label it HDVA292 
   Disk 1 of 5. 

2) In a similar manner, UNZIP the file DISK2.ZIP (yields DATA2.CAB). Label 
   this floppy HDVA292 Disk 2 of 5. 

3) In a similar manner, UNZIP the file DISK3.ZIP (yields DATA3.CAB). Label 
   this floppy HDVA292 Disk 3 of 5. 

4) In a similar manner, UNZIP the file DISK4.ZIP (yields DATA4.CAB). Label 
   this floppy HDVA292 Disk 4 of 5. 

5) In a similar manner, UNZIP the file DISK5.ZIP (yields DATA5.CAB). Label 
   this floppy HDVA292 Disk 5 of 5. 


Now, let's use the installation floppies to update the HDVA292 Software. Make 
sure that the HDVA292 Analyzer is powered-on. If it is powered-on and the 
HDVA292 Application is running, then first exit the HDVA292 Application. 

1) Insert HDVA292 Disk1 into the HDVA292 Analyzer's floppy drive. 

2) Open the Start menu by pressing the Start button found in the lower left-
   hand corner of the display. 

3) Select "Run ..." 

4) In the Run dialog, type A:\SETUP and then press the OK button. Follow the 
   Setup Wizard instructions which include inserting Disks 2, 3, 4 and 5. 

5) At the end of the installation, the Reboot? dialog will appear. After you 
   press the OK button to reboot, wait until WindowsNT writes data to the disk. 
   After the data is written to disk and while the analyzer is rebooting, remove 
   Disk 5 from the floppy drive.