HGREADME.TXT

Unzipping the hdsg_122.zip file will yield the following contents:

disk1.zip
disk2.zip
disk3.zip

The instructions below will indicate how to make installation floppies from
the HDSG's ZIP file.  After the floppies have been created, these diskettes
can be used to update your HDSG292 software.

The zip files have been compressed with the PKZIP utility.  This procedure
assumes that you have access to the PKUNZIP utility and understand how to 
decompress a zipped file. 

FLOPPY DISK INSTALLATION

First unzip the files to make a three-disk set that can then be 
installed via the HDVA292's floppy drive. Have three blank,
formatted floppy disks available for copying the install files onto.

1) PKUNZIP the file hdsg_122.zip to retrieve three new zip files:  disk1.zip,
   disk2.zip and disk3.zip
2) Insert a blank floppy disk into the floppy drive. PKUNZIP the file
   disk1.zip onto the floppy disk. This will decompress and copy the entire
   contents of disk1.zip to the floppy drive. Remove the floppy disk and label
   it HDSG292 Disk 1.
3) In a similar manner, PKUNZIP the file disk2.zip. Label this floppy
   HDSG292 Disk 2.  
4) Finally, PKUNZIP the file disk3.zip. Label this floppy HDSG292 Disk 3.

Now, use the installation floppies to update the HDSG292 Software.
Make sure that the HDVA292 or HDSG292 Analyzer is powered-on. When it 
is powered-on and the HDVA292 Application is running, then select OFF 
and exit the HDVA292 application.  Repeat this step to exit the HDSG292 
application. Leave the platform operating system (WindowsNT) running.

1) Insert HDSG292 Disk1 into the HDVA292 Analyzer's floppy drive.
2) Open the Start menu by pressing the Start button found in the lower
   left-hand corner of the display.

3) Select "Run ..."
4) In the Run dialog, type A:\SETUP and then press the OK button.  Follow
   the Setup Wizard instructions, including inserting Disk 2 and Disk 3 when 
   called for. 
5) At the end of the installation, the Reboot? dialog will appear.  After
   you press the OK button to reboot, wait until WindowsNT writes data to the
   disk. After the data is written to disk and while the analyzer is rebooting,
   remove Disk3 from the floppy drive.


Software Download Terms and Conditions:
---------------------------------------
SyntheSys Research, Inc. provides utility software to assist qualified users in 
supporting applications of our instruments. While the software has been tested 
in specific configurations, we cannot guarantee that it will operate correctly 
in all applications. The software is provided for free on an “as-is” basis, 
without any representation of warranty. SyntheSys Research disclaims all 
warranties, expressed or implied, including fitness for the application 
requirements and non-infringement of intellectual property rights. In no event 
shall SyntheSys Research be liable for any direct, indirect, incidental or 
consequential damages arising out of, or connected to the use of this software.